Audi A6 C6 Rear Door Wiring Harness Cable Loom Left Right N/O/S 4F1971693G

Audi A6 C6 Rear Door Wiring Harness Cable Loom Left Right N/O/S is an original electrical system component from the Wires, harnesses, and connectors group, designed to support the rear doors on both the left and right sides. It ensures a stable electrical connection between the doors and the vehicle body, which translates into the proper operation of electrical components in the rear of the vehicle. This solution is dedicated to users who want to maintain the factory wiring architecture in their Audi.

Specifications and technical data

• SKU: 4F1971693G
• Mark: Audi
• Condition: Used
• OEM Part Number: 4F1971693G
• Substitutable numbers: 4F1971693G, 4F1 971 693 G, 4F1971693E, 4F1 971 693 E
• Location on the vehicle: Rear, Right, Left
• Category: Wiring Harnesses, Cables & Connectors

Purpose and vehicle placement

The presented wiring harness is designed for installation in the rear of the vehicle, supporting both the left and right sides. Its placement in the rear door area means the component is responsible for transmitting signals and power to components located in the door panels and their vicinity. This makes it possible to maintain the consistency of the electrical system throughout the entire rear cabin zone.

Technical characteristics of the harness

The harness belongs to the Wires, harnesses, and connectors category, which means it has been constructed with a focus on stable signal routing and protection of wires against mechanical damage. The connectors used are matched to the factory sockets in the Audi, which facilitates installation and reduces the risk of installation errors. The layout of the wires and mounting points is adapted to the geometry of the door and body, allowing for proper routing of the harness without tension.

Benefits of using an original Audi harness

Using an original wiring harness in an Audi A6 C6 allows for compliance with the vehicle's factory technical documentation. This translates into:

• a secure fit of the length and routing of the wires to the rear of the body,
• compatibility with factory connectors in the doors and pillars,
• reduced risk of electrical communication problems in the rear door area.

For users who value system consistency and want to avoid modifications, the original harness is a practical and safe solution. Using components consistent with the manufacturer's design also facilitates easier diagnostics of potential faults in the future.

Component condition and service application

The offered wiring harness is a salvaged part intended for reinstallation in a vehicle as a service part. It is suitable for repairs following mechanical damage to the harness, interference with the installation, or replacement of door components when it is necessary to restore the correct routing of the wires. This is a practical solution for workshops and individual users who want to restore full electrical functionality to the rear doors of an Audi A6 C6.

Selection support and additional information

Before purchasing, it is worth verifying the compatibility of the harness with the specific equipment configuration of the vehicle, especially in the context of connector layout and supported functions in the rear doors. In case of doubt, it may be helpful to compare the wire layout with the component currently installed in the car or consult a service center specializing in the Audi brand.

If you are planning a comprehensive repair or upgrade of the rear door zone in your Audi and need other components from the same group, such as wire sections, additional harnesses, or door installation connectors, check the available parts in the Audi wires, harnesses, and connectors category.

For a broader perspective on the use of salvaged components in body and installation repairs, it is worth reading the guide Post-accident repair of your car: why are used body parts a better choice than replacements?, which discusses the practical aspects of selecting used components.