Range Rover Evoque L551 Hood Bonnet Spring Strut Left Right N/O/S K8D2-16C826-AB

Range Rover Evoque L551 Hood Bonnet Spring Strut Left Right is a precision component from the Gas springs and struts category, designed for stable support and controlled opening of the hood in this model. Using a dedicated strut on the left and right side ensures predictable operation of the cover, improves the comfort of engine compartment maintenance, and reduces the risk of it falling uncontrollably.

Specifications and technical data

• SKU: K8D2-16C826-AB
• Mark: Range Rover
• Condition: Used
• OEM Part Number: K8D2-16C826-AB
• Substitutable numbers: K8D2-16C826-AB, K8D216C826AB, 535123471
• Location on the vehicle: Right, Left
• Part type: Bonnet Lift Support
• Category: Lift Supports & Prop Rods

Purpose and function in the Range Rover Evoque L551

The hood strut in the Range Rover Evoque L551 is responsible for safely guiding the cover during opening and closing. Properly selected gas characteristics allow for smooth lifting of the hood without jerking, as well as stable holding in the upper position during service work or inspections.

This component works in pairs – on the left and right side – which allows for even distribution of loads on the hood hinges and reduces their wear. Using the correct strut is important both for operational ergonomics and for protecting body components from excessive stress.

Construction and technical characteristics

The hood strut from this series belongs to the Gas springs and struts group, which means it uses compressed gas to generate supporting force. This design provides:

• controlled, linear movement throughout the entire operating range,
• adequate rigidity at maximum hood opening,
• reduction of vibrations when closing the cover.

The placement on the vehicle covers the right and left sides, making it possible to maintain the factory operating geometry of the hood and the correct distribution of forces in the hinges and mounting points.

Benefits of using an original strut

Using a dedicated hood strut in the Range Rover Evoque L551 allows you to maintain performance parameters close to factory specifications. Key advantages include:

• stable hood support during service and diagnostic activities,
• reduced mechanical load on hinges and mounts,
• more predictable behavior of the cover at low and high ambient temperatures,
• maintaining the correct opening geometry, facilitating access to components in the engine compartment.

The used component allows for an economical restoration of the correct operation of the hood lifting system, while maintaining a design consistent with the factory solution.

Selection and installation in the vehicle

When selecting a hood strut for the Range Rover Evoque L551, it is crucial to match it to the specific model and the correct placement on the vehicle (right/left side). Installation involves seating the strut in the mounting points provided by the manufacturer, while maintaining the correct orientation of the working element.

In practice, it is recommended to:

• replace struts in pairs to avoid differences in supporting force on both sides,
• check the condition of sockets and mounts before installation,
• verify the full range of hood movement after installation, without adding extra weight to the cover.

Expanding the hood lifting system in Range Rover

If you are planning a comprehensive repair or upgrade of the engine area in your Range Rover and need other components from the same group, such as additional struts, gas springs, or supports, check out the available parts in the Range Rover Gas springs and struts category.

To better understand the impact of components supporting the engine unit on the durability of the entire system, as well as the risks associated with purchasing used components, it is worth reading the guide on modifications and selecting parts for turbocharged engines: see the article on safe power increases in Audi RS3 and purchasing used turbochargers.