VW Volkswagen Passat B6 ABS Brake Hydraulic Pump Control Unit 3C0614109AF

VW Volkswagen Passat B6 ABS Brake Hydraulic Pump Control Unit is an original component from the ABS and ESP System category, designed for Volkswagen vehicles. It is a complete solution combining the hydraulic section with the control module, which ensures efficient and predictable operation of the anti-lock braking system during braking.

Specifications and technical data

• SKU: 3C0614109AF
• Mark: Volkswagen
• Condition: Used
• OEM Part Number: 3C0614109AF
• Substitutable numbers: 3C0614109AF, 3C0 614 109 AF
• Category: ABS & Stability Hydraulic Units

Technical characteristics and function in the braking system

The presented hydraulic pump integrated with the ABS control unit is responsible for precise pressure dosing in the brake circuits and dynamic control of valve operation in emergency braking situations. By working with wheel speed sensors and vehicle electronics, the module stabilizes the vehicle's path, reduces slippage, and supports the driver in maintaining control of the car.

The solution used in the Passat B6 was designed by the vehicle manufacturer, which ensures consistency with the factory electrical and hydraulic architecture. Matching the operating parameters to the specific vehicle platform translates into repeatable, predictable braking system reactions in various road conditions.

Benefits of using an original ABS module

Using a factory module from the ABS and ESP System category instead of an unverified replacement allows you to maintain the original performance characteristics of safety systems. The original design ensures:

• compatibility with the software and control logic provided by the vehicle manufacturer,
• proper cooperation with wheel speed sensors and the electrical installation,
• stable pressure in the brake circuits during intensive braking,
• preservation of the factory operating parameters of driver assistance systems.

For the user, this means more predictable vehicle behavior in critical situations and a lower risk of problems resulting from incomplete electronics compatibility.

Component condition and practical application

The offered item is in used condition, which allows for economical vehicle repair while maintaining original build quality. This type of solution is particularly beneficial in cases of ABS module damage, where a new factory component can be expensive, and replacements do not always provide the appropriate level of fitment.

The hydraulic pump with the ABS control unit is intended for use in the Volkswagen Passat B6, where it plays a key role in the operation of the braking system and electronic stability control systems. Proper selection of parts according to the OEM number and interchangeable numbers helps avoid problems with installation and configuration.

Installation recommendations and additional information

Before installation, it is recommended to verify compatibility with the specific vehicle equipment version and to perform adaptation and bleeding of the brake system in accordance with the manufacturer's service procedures. The module installation should be performed by a workshop equipped with an appropriate diagnostic tester, which will allow for correct coding of the controller and checking for any potential errors.

If you are planning a comprehensive repair or upgrade of the braking zone in your Volkswagen and need other components from the same group, such as pumps, controllers, or stability control modules, check the available parts in the ABS and ESP System Volkswagen category.

For drivers considering used drivetrain components and wanting to better understand the advantages of original components over random replacements, the following article will be helpful: Humming differential? Find out why a used OEM drive axle is a better investment than an uncertain replacement.